Common faults of self dumping hydraulic lifting system and simple maintenance solutions overseas

Jul 07, 2026

Leave a message

1, The causes and simple solutions of the four major high-frequency faults
(1)Weak lifting ability and slow lifting speed
Most of them are caused by insufficient hydraulic oil, deteriorated oil, or air leakage in the intake pipe. Simple maintenance: First check the oil level in the hydraulic oil tank, and if it is insufficient, promptly replenish the same type of anti-wear hydraulic oil; Check whether the intake hose of the oil pump is cracked or the clamp is loose, tighten or replace the damaged air pipe; It is recommended to replace the hydraulic oil every 2 months in a long-term high-temperature environment to avoid thinning of the oil and insufficient pressure.
2()Oil leakage from oil pipes and oil cylinder seals
Dust and heavy loads can accelerate the aging of oil seals and wear of oil pipes. Simple maintenance: Before daily driving, check the outer wall of the oil cylinder and the joint oil pipe. If there is slight oil leakage, temporarily tighten the joint clamp; If the oil seal is damaged, it needs to be replaced with a high and low temperature resistant oil seal of the same specification. A wear-resistant protective sleeve should be added to the outer layer of the oil pipe to reduce friction and damage caused by gravel. Clean the sand and gravel on the surface of the oil cylinder when storing the vehicle to avoid particles scratching the seals.
(3)Lifting stutter, automatic descent midway
The core reason is the blockage of the hydraulic one-way valve and internal pressure relief. Simple maintenance: After turning off the power, disassemble the one-way valve, rinse the internal impurities and cement dust with diesel, air dry and reinstall it; If the drop is severe, it is necessary to check whether the hydraulic lock has failed. If there are no accessories overseas, the single loading weight can be reduced to reduce system pressure.
Lift completely unresponsive
It is divided into two categories: power failure and oil circuit blockage. Simple maintenance: First, check the power take-off to confirm that the transmission shaft is properly engaged; If the power take-off is normal, disassemble the hydraulic filter to clean the clogged dust. If the filter is damaged, replace it directly to prevent impurities from entering the oil cylinder and causing irreversible damage.
2, Daily maintenance points for long-term use overseas
Check the oil level, oil pipe, and oil cylinder for leaks, and the bracket for deformation 5 minutes before driving every day;
Avoid stepping on the accelerator and applying pressure during unloading at the construction site. Lift slowly to reduce the impact of high pressure on the system;
Timely rinse hydraulic components after rainy season and sandstorm operations, as sediment accumulation will accelerate the wear of seals;
Long term idleness requires the oil cylinder to be completely retracted to prevent the piston rod from being exposed to sunlight and rust, thereby extending the lifespan of the oil seal.
3, Procurement suggestion
When purchasing dump trailers from remote overseas areas, priority should be given to upgrading the hydraulic system with thickened oil cylinders, thickened high-pressure oil pipes, and external dust covers. The original factory is equipped with high-temperature resistant and wear-resistant accessories to reduce failures from the source and significantly reduce overseas maintenance costs.

Send Inquiry