The fuel quality in remote overseas areas varies greatly, with diesel fuel mixed with water and impurities being a frequent problem for fleets. Once refilled, it can cause fuel injector wear, frequent filter blockage, and engine stalling during transportation, resulting in high maintenance losses for cross-border transportation. Drivers can quickly identify and avoid risks in advance by mastering on-site identification methods. Before refueling, it is recommended to prepare a clean and transparent plastic or glass bottle. When refueling, take a small amount of oil sample from the oil gun outlet and let it stand for three to five minutes for observation. Qualified diesel should be light yellow or amber in color, clear and transparent without white mist. If the oil sample appears white, cloudy, and milky, it means that it has been emulsified into water. If there are clear layers at the bottom of the bottle and transparent liquid in the lower layer, it indicates the presence of free water, and rust, sediment, and black flocculent substances settle at the bottom, indicating that impurities exceed the standard. In addition to visual observation, water detection paste can also be used to assist in judgment. Apply the paste to the end of a thin rod and insert it into the bottom of the oil sample. If the paste changes color, it confirms that it contains water. This method is suitable for sampling from the bottom of an oil tank, as many free water deposits in the lower layer, and only taking the surface oil sample is prone to missed detection. At the same time, pay attention to the odor of the oil. Normal diesel has a stable odor, but if it has a earthy or pungent odor, it is likely to contain impurities or moisture. Also remember the rear warning signal of the vehicle. After adding inferior fuel, there may be idle shaking, weak acceleration, white smoke from the exhaust, frequent alarms from the oil-water separator, and filter blockage in a short period of time. If such situations occur, immediately stop using the batch of fuel. In daily fleet management, it is recommended that drivers try to fix reliable fuel supply points as much as possible, keep oil samples every time they refuel, and promptly discharge the oil-water separator after refueling. Do not have a lucky mentality and do not wait for engine parts to be damaged before handling. This simple screening operation is time-consuming and suitable for construction sites and cross-border long-distance fleets to use on overseas sites, reducing downtime losses caused by oil failures.
