The trailer towing pin is the core component connecting the tractor and trailer. It wears out faster under overseas long-distance and construction site heavy load conditions. Once the gap is too large, there is a risk of shaking and uncoupling. Before driving, professional measuring tools are not needed, and a simple shaking with the naked eye can preliminarily determine the wear condition. Firstly, clean the sediment and oil stains on the surface of the traction pin. The dirt will cover the worn steps and make it difficult to see the wear marks. Focus on the bearing arc surface in contact with the traction pin and the traction saddle. Normally, the surface of the pin is smooth and uniform. If there are obvious circular grooves or steps, it is wear caused by long-term friction. The deeper the groove, the higher the risk. At the same time, observe whether there are peeling, chipping, or cracks on the surface of the pin. If cracks appear, it must be stopped immediately and cannot continue on the road. Next, check the fit gap. After the lock buckle is fully locked in place, observe the position of the saddle and the traction pin. The fit should be tight and there should be no obvious looseness. Ask the assistant to gently push the trailer left and right at the rear of the trailer, and visually observe the position of the traction pin. If there is obvious movement or gap between the saddle and the pin, accompanied by shaking and abnormal noise, it indicates that the wear has exceeded the standard. It is also necessary to check the traction pin base to see if the base connecting plate and fixing bolts are loose or deformed. If the base cracks or the bolts are loose, even if the pin itself is not worn out, it will still produce abnormal shaking. Many drivers easily overlook the fixed position of the base. In addition, pay attention to the contact surface of the lock block. If the saddle lock block and the traction pin bite position are worn on one side or have a slanted mouth, it is mostly caused by long-term unbalanced load and excessive turning. This kind of single-sided wear hazard is greater than uniform wear and is prone to loose locking. It is also necessary to distinguish between normal use marks and dangerous wear and tear. Slight shiny friction marks are considered normal, as long as there are no grooves or gaps, they can continue to be used. Once clear steps are visible to the naked eye, they should be disassembled for inspection, measured accurately with calipers, and replaced in advance. The procurement cycle of accessories for overseas construction sites is long. It is recommended to include the traction pin and saddle lock block in the inspection items before each vehicle is dispatched. Do not wait until the trailer tilts during driving to pay attention and avoid major accidents caused by traction connection failure from the source.
